• 0 Posts
  • 12 Comments
Joined 7 天前
cake
Cake day: 2026年7月29日

help-circle






  • This is tangential, but I recently learned quite a bit about hospice care in Oregon. I was dating someone who worked in the industry. She said that private equity was buying up the industry, intending to bill Medicare for as much as possible. I asked why she and her hard-working co-workers didn’t start up their own hospice. Don’t quote me on the specifics, but 1) a new hospice here has to generate no profit for the first X years and 2) you have to have something like half a million in reserves in order to be allowed the license to start one.

    The laws were well-intentioned, but they end up being a way for the wealthy to continue generating income on the backs of everyone else. If you have the industry knowledge and funding to start a hospice, you can do it, then sell it off to private equity after a few years. Rinse and repeat. The rich get richer and we all pay for it, largely via Medicare.


  • Check that each leg of the stator is good by checking that each yellow wire has about 0.3 - 0.4 ohms resistance against the other yellow wires, and that none of the yellow wires have continuity to ground. If one leg of your stator goes bad, it can overtax the remaining leg(s).

    Corrosion causes resistance, which creates heat and lower voltage. Are just the connectors corroded, or are the wires also corroded?

    To clean connectors, I use DeOxit. Spray it on, then plug and unplug the connector a few times. If that’s not enough, I use a soft, brass bristle brush. If that’s not enough to clean the connector to gleaming, then I replace the connector.

    Incidentally, it’s common for motorcycles to barely charge at idle. You often don’t hit a 13.2 - 14.4V cutoff until a few thousand RPM.